Hello,
I bought one of the new Snap Bun mats about a month ago having owned one of the older (tarp faced) versions that was still going fine on new foam, but the straps were starting to hang off a bit. It's days were numbered.
There's several things I like about it over the old one - better handles, non slip base and the Velcro strap release mechanism...
But, the top sheet of thinner foam keeps moving around and ending up 10-15cm down one end of the pad... It's a real pain to get it central again (involves loads of back folding and holding the top layer through the case - and this is something I've noticed in a few folks snap buns. It's almost as of the case is too baggy or doesn't have enough rigidity in it. Second, when trying to move the foam back to its proper place I opened up the mat, gripped the thick layer so I could move one against the other, and my fingers went straight though the foam really easily.. I stopped there not to wanting to rip a big chunk out. I'm no foam expert, but that didn't seem too clever :-/ Not sure what it means for the longevity of the foam etc..
Anyone else had this - or found a way to stop the top foam shizzling about? I'm not as impressed as I was with my original Bun...